Huxley Z axis strikes again

20130831_203856.jpg

 So I thought the printer was running well enough, turns out not only my design had a few bearing size issues, but my Z axis was trying to travel a little too fast, and skipping a few steps.

Oddly this doesn’t show up on all prints, I now have the Z axis set to 2mm/s and watching snails overtake it.

At least it’s printing correctly – well mostly.


 Post details 

 Leave a comment 

Your email address will not be published. Required fields are marked *

*


 © 2018 - Technological Adventures of a Sasquatch