September 1, 2013


Huxley Z axis strikes again

by Sasq
Categories: 3D Printer
Tags: No Tags
Comments: Leave a Comment

 So I thought the printer was running well enough, turns out not only my design had a few bearing size issues, but my Z axis was trying to travel a little too fast, and skipping a few steps.

Oddly this doesn’t show up on all prints, I now have the Z axis set to 2mm/s and watching snails overtake it.

At least it’s printing correctly – well mostly.

Leave a Reply

Your email address will not be published. Required fields are marked *

Today is Saturday
April 4, 2020